PRO-CUT press center

NEW PRO-CUT ADAPTERS MAKE MACHINING BIG FORD TRUCK ROTORS A SNAP

June 27, 2003

 

WEST LEBANON, NH, June 27, 2003 -- New adapters now available from Pro-Cut International make it possible and easy use the Pro-Cut on-car disc brake lathes to machine front rotors on Ford E and F series trucks. And new arm extensions allow the Pro-Cut lathe to reach and machine rear rotors on these vehicles as well.

 

"The new heavy duty adapters, combined with the arm extenders, makes precise rotor machining at all four corners of Ford's 450 and 550 trucks a fast, straightforward and profitable operation -- right on the vehicle. There is no need to disassemble the hub or remove the rotors, front or rear, on these popular workhorse vehicles," said Jeff Hastings, president of Pro-Cut

 

Pro-Cut's PFM 9.0 on car disc brake lathe is designed to machine virtually any brake rotor on most vehicles in 10 minutes or less. The first on-car lathe approved by the big three auto manufacturers plus most other car companies, the PFM 9.0 provides computer-controlled accuracy to within .001", and one-cut, finish cut technology removes up to .020" from each side of the rotor in a single pass

 

"The Pro-Cut PFM 9.0 is designed to produce smooth, accurate brake rotor finishing right on the car or truck. Just four simple steps will completely cut and finish virtually any rotor. The adapters are simple-to-use, and a wide variety of adapters connect the lathe to virtually every vehicle on the road today, up to medium duty trucks," Hastings said..

 

Pro-Cut International is patent-holder and marketer of the Pro-Cut series of on-car brake lathes, including the VBG620 and PFM 9.0 SmartLathe. The world's largest supplier of on-car disc brake lathes, Pro-Cut is located in West Lebanon, NH. You can reach them by telephone at 800-543-6618, fax at 603-298-8404, and by e-mail at info@procutinternational.com. Their internet address is www.procutinternational.com.

 

For more information contact Jeff Hastings @ 800-543-6618